Greetings all,

I just had to reapply PTVupgrade and Instantcake to the drive on my HDVR2 (Direct TV).

The upgrade went fine. I also applied Tomato to my Linksys WRT54G (V2.2) and set it in wireless bridge mode. I named it the same as my AP.

I plugged in the Tivo and bridge in so I can check to see if it can be accessed over my network before I activate the unit with DTV.

I've used Angry IP to scan for it but cannot "see" the tivo. I'm sure I've missed a simple step. Any suggestions?

Also, I saw a post earlier about DTV perhaps screwing with the hack. Any truth to this?