Hello: Someone told me to look for the "cake won't bake" thread but I can't seem to find it.

I put the CD-ROM on the MASTER connection on the IDE Cable where my C-Drive normally is and set it to Primary IDE Slave: I used Slave(SL) as described below: there are only 3 jumper settings. It is actually a DVD-ROM which shouldn't make a difference (should it?)

Master(MA) Configures the drive as the master.
Set the DVD-ROM drive as master if the drive is the only device connected to the IDE card.

Slave(SL) Configures the drive as the slave.
Set the DVD-ROM drive as slave if the drive is daisy-chained with a hard-disk drive on an IDE card.

CSEL(CS) Configures the drive by using host interface signal CSEL (Cable Select).
This is the default setting for Dell desktop and workstation systems

I then took the drive for the TIVO and put it on the next connector on the IDE cable where my D-Drive normally goes. It is a Seagate DB35 and I set it as "Master or Single Drive." My choices are that, or "drive is slave" (no jumper at all), "Master with non ATA compatible slave" (which requires a second jumper), or "limit drive capacity" which of course I don't want.

I booted the computer and Instant Cake boots up no problem. I get to where it says "press enter and we will begin baking your Instantcake" -- and I pressed "enter" and absolutely nothing appears to be happening.