Previous Thread
Categories: General Discussion
Hello everyone.
I just downloaded InstantCake for my Hughes Hdvr2. I've burned the ISO image onto a CD. My question is for setting up my computer to boot the CD. After looking at the instructions, I am confused as to the computer setup.
1. Should the Cdrom be on the primary or the secondary IDE slot on the motherboard? The instructions say it should be connected as the Primary slave device. If it is to be connected on the primary IDE, should the jumper on the CDrom be slave?
2. What should the new Hardrive be on? The primary IDE slot as master? The Secondary IDE slot as master?
Sorry for the nooby questions...
Jim
Add Your Reply
Sponsored Links
Copyright © 2008
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
Drobo Space |
DVR playground |
MediaSmart Home |
Monster Community |
MotoDash |
My DigitalEntertainer |
My Open Router |
Presto Place |
Robo Community |
Sansa Community |
Sling Community |
TechLore |
TiVo Community |
TouchSmart Community
OK,
I got everything working. Wow! this software is great and very easy to do the upgrade. The only complaint, and it is a small one, is that the ISO download is software version 6.2a-01-2-151. My current software on my other Directv is 6.2a-01-2-361. This only means that I had to force a call, download the update and wait for the update to install.
Other than that, the software worked perfectly.