Previous Thread
I have a HR10-250 and an S3.
I had network access working fine to the HR10-250 using a FA-120 USB adaptor and a WGA54G gaming adaptor.
After I purchased the S3 I decided to try to remove the WGA54G and try to connect them both using a ZyXEL P-330W as a bridge.
After configuring the P-330W as a bridge and connecting both the HR10-250 and the S3 to it, the S3 connects to the network with no problem but the HR10-250 is no longer reachable over the network.
Does anyone have any suggestions?
Add Your Reply
Sponsored Links
Copyright © 2008
Capable Networks LLC.. All Rights Reserved.
RSS |
Privacy Policy |
Advertise With Us |
Terms of Use |
About Us |
Contact Us |
Site Map
Our Capable Community Network:
Drobo Space |
DVR playground |
MediaSmart Home |
Monster Community |
MotoDash |
My DigitalEntertainer |
My Open Router |
Presto Place |
Robo Community |
Sansa Community |
Sling Community |
TechLore |
TiVo Community
Also, something in the setup was losing the Internet connection through my main router. Whenever it was re-booted everything worked again.
For now I have removed the bridge, put the wireless gaming back on the HR10-250 and a Tivo wireless adapter on the S3.
With this configuration, the Internet connection remains stable, the S3 can connect with no problems, and I can still connect to the HR10-250 with either Telnet or FTP.
Now to see whether I can set the HR10-250 to use a Static IP address and upgrade it to the 6.3b software without losing my network connection.