Ok I am sure this is too basic at this point in this forum, but I am trying to use my dwnld istcake for a R10 in order to upgrade to a 300 gb (in part because my original hdd is going bad) as I start to run the cd with the new hdd as the secondary master i get the message ..."just press enter to start baking..." 

then it hangs no action...

I am using a Dell 4600, the new version of icake (just downloaded today 10.22.06) and my wife is about to kick my butt if I dont get this up and running soon. Also I can not get the CD rom to show up as a primary slave

Any advise or direction?