January 3, 2005 8:45 AM

TimCarney said:

I used InstantCake on a Single Drive (250GB) SAT-T60 with CacheCard. After startup I installed .NETREADY, rebooted, installed PTVtivoweb and everything is cool.

Started new InstantCake on a Two Drive (120GB + 120GB) SAT-T60 with CacheCard. After startup I installed .NETREADY, rebooted, tried to upload PTVtivoweb and upload locks up. :( I figure the upload is failing because the .NETREADY installed failed. I have tried multiple times (.NETREADY, Reboot and upload of PTVtivoweb) and they all fail. (telnet and ftp work but file transfer fails)

Any ideas other than InstantCake a Single Drive get TivoWeb up and running then adding second drive?

Thanks,
Tim

Tim,

Not sure I understand your logic here - the software does work, and you've proven it by successfully installing it. It appears you've gotten everything running in a single-drive environment. I'd recommend you go back and try again, but ensure you are preparing your dual-drive replacement set correctly, and that you are connecting everything including the network card, cables, etc properly before proceeding with the additional software installation. Chances are that you've not connected somethign properly.

For answers to commonly asked questions, please refer to the
InstantCake Instructions and Release Notes,
Official InstantCake Discussion Thread, and the
Official PTVnet Discussion Thread